PS Audio Stellar M700, Руководство пользователя для владельца

Страница: 7 / 16

Getting Started
®
Stellar
™
M700 Mono Amplifier
Plugging in the
Connecting
Cables
The Stellar M700 amplifier accepts either single-ended RCA or balanced XLR connections
to the preamplifier or DAC feeding it. Regardless of the cable chosen, the Stellar will treat
the incoming signal in such a way that it becomes balanced throughout the amplifier’s
circuitry.
Our preference for connection to the preamplifier is balanced XLR cables. Balanced
signals are lower in noise and take advantage of common mode rejection. Single-ended
RCA cables can also be good, but we shy away from their use at lengths exceeding two
meters.
Plugging in the
Power Cable
Once connections have been made to both the loudspeakers and the preamplifier, it is
time to plug the AC power source in.
The M700 is voltage specific. It ONLY operates at the voltage set at the factory. Do NOT
plug the M700 into a voltage other than what it is set for. Failure to observe this rule may
damage the Stellar.
You are now ready to enjoy your first listen to the Stellar M700 Mono Amplifier. Making
sure the preamplifier and the system is on, push the standby button on the top left corner
of the M700 front panel. When the blinking stops and the PS logo turns steady on, the
amplifier is ready to play music.
WARNING! DO NOT MAKE CONNECTIONS OR PLUG THE UNIT INTO AC POWER
WITH THE REAR POWER SWITCH IN THE ON POSITION. THIS CAN HARM THE
DEVICE AND CAUSE DAMAGE THAT WILL VOID THE WARRANTY.
6