4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 [email protected] www.psaudio.com
Questions and Answers 5
®
Questions And Answers
©2006 PS Audio International Inc. All rights reserved.
Owner’s Reference
DLIII Digital Link DAC
interconnects are working properly.
You do not need to install a driver for the USB connection. The DLIII has a built in driver that should
communicate with your computer automatically. Make sure the computer is booted properly and on.
Make sure the DLIII is on. Connect a USB cable and the computer should indicate it recognizes a new
device has been installed and should install the appropriate software drivers to operate it.
You can check and see by going to your computer’s control panel and look under USB devices. See
if the DLIII is recognized.
The DLIII is specifi c to your country’s voltage. Do not use the DLIII on a voltage higher than it is
rated for. For instance, do not take a 120 volt rated DLIII and attempt to use it in a 230 volt country.
Failure to observe this cautionary note will void your warranty and may damage the DAC. If you
need to operate the DLIII at a voltage other than the voltage it was designed for, contact your dealer,
distributor or the factory.
What voltages
can the amp run
on?
Do I need to install
a software driver for
the USB?
