7
Attach Rack to Ledger Board
1. Once the ledger board is installed, place your assembled rack against the ledger board as shown
below.
WARNING: Make sure you have enough ceiling height to rotate the rack up against the
ledger board without hitting the ceiling. See table below for ceiling height requirements.
2. Make sure uprights are parallel to the wall before marking and drilling holes for mounting. Have a
second person hold it in place while you mark the hole locations and drill pilot holes for your lag
bolts using the 7/32” drill bit, drill to a minimum depth of 2 ½” (Figure 1).
3. Attach foot anchors to the bottom of the uprights (Figure 2).
4. Make sure bottom of uprights are 42” apart before anchoring to the floor.
5. Once rack is anchored to the floor, fully tighten all hardware.
6
Attach Rack to Ledger Board
1. Once the ledger board is installed, place your assembled rack against the ledger board as shown below.
WARNING:
Make sure you have enough ceiling height to rotate the rack up against the ledger board
without hitting the ceiling. See table below for required heights needed.
2. Make sure uprights are parallel to the wall before marking and drilling holes for mounting. Have one per-
son hold it in place while you mark the hole locations and drill pilot holes for your lag bolts using the
7/32” drill bit, to a minimum depth of 2-1/2”. (Figure 1)
3. Attach foot anchors to the bottom of the uprights a shown in Figure 2.
4. Bottom of uprights can now be spaced at 42” and anchored to the floor. (Hardware not supplied)
5. Tighten all hardware after anchoring to the floor.
[email protected] 701-566-0452
RACK
HEIGHT REQ’D.
95-18
99”
95-42
107”
81-18
85”
81-42
95”
10
9
4
Figure 1
NOTE: If ceiling height is less than min.
Contact Customer Service.
Figure 2
11
6
7
5
6
Rack
Height Required
95-18
99”
95-42
107”
81-18
85”
81-42
95”
NOTE: If ceiling height is
less than minimum, contact
Customer Service.
Figure 1
Figure 2
10
9
8