Prs MARY CRIES, Инструкция по эксплуатации

Страница: 7 / 8

SE
E I
LL
U
ST
R
AT
IO
N O
N P
AG
E 6
EN
G
LISH
CONNECTING:
1. For optimum use, we recommend a regulated and/or isolated 9V DC power adapter
that is rated higher than the pedal’s current rating (or collection of pedals if using a
daisy chain configuration). Only use a 9V DC power supply with the following center
negative symbol:
(Note: Battery Power – By removing the four screws on the rear panel, you can
access the battery terminal and power the pedal via 9V DC battery).
2. Input Jack – Plug the cable from your source into the input jack. (Note: When
using a 9V battery, we recommend unplugging from the input jack to preserve
battery power when not in use).
3. Output Jack - Connect the cable from the output jack to another pedal or directly
into your amplifier.
BASIC OPERATION:
4. True Bypass On/Off Switch – Use this to turn the effect on and off. (Note: True
Bypass – This is a hardwire bypass allowing no coloration of your tone while the
pedal is in the off position).
5. Compression – Use this to adjust the compression level of your signal. Turn
counterclockwise for less compression or clockwise for more compression.
6. Output Gain – Adjusts the overall level of the compressed signal.
7. Compression Indicator – Mary Cries uses an LED indicator to express where the
compressors floor and ceiling are. You know you are at the floor when the LED is not
illuminated. The closer to the ceiling you get, the brighter the LED indicator becomes.