Proxxon DSH/E, Руководство пользователя, Страница: 15 / 20

- 15 -
11 Care and maintenance
After use
CAUTION!
Pull the mains plug before making any adjustments,
performing maintenance work, or carrying out repairs!
Failure to do this may result in serious personal injury.
NOTE:
The scroll saw is basically maintenance free. However, to
ensure a long service life you should clean the device after
each use with a soft cloth, swab, or brush. A vacuum cleaner
is also advisable for this. Ensure all ventilation slots are free
from obstruction.
External cleaning of the housing can be carried out using a
soft, possibly moist cloth. While doing so, a mild detergent or
other suitable cleansing agent can be used.
WARNING:
To avoid fire or toxic reaction, never use gasoline, naphtha,
acetone, lacquer thinner, or similar highly volatile solvents to
clean the scroll saw.
These products have low flash points and could explode if
used to clean the saw.
NEVER smoke while using solvents: Smoking near solvents
could ignite an explosion or fire and cause serious injury.
ALWAYS WORK in a well ventilated area to prevent the
accumulation of dangerous fumes, continuesly supply the
work area with a constant source of fresh air:
Lack of ventilation while using solvents could cause serious
personal health risks, fire, or environmental hazards.
Do not allow brake fluids, gasoline, or penetrating oils to
come in contact with the plastic parts. They contain
chemicals that can damage or destroy plastics!
When servicing use only PROXXON replacement parts. Use of
any other parts may create a hazard or cause product
damage.
Any attempt to repair or replace electrical parts on this tool
may create a hazard unless repair is done by a qualified
service technician.
Repair service is available at your PROXXON service center
(You find the address at address at the back of this manual).
12 Accessories
Replace damaged or worn saw blades immediately. They
represent a safety risk and worsen the work result.
Please use PROXXON accessories. NOTE: The use of
improper accessories may cause hazards.
Use 5 inch Plain or Pin-end blades. Actually PROXXON
provides:
"Super-Cut" scroll saw blades:
Special industrial quality steel for prolonged cutting capacity.
NO 28 106 Very fine-toothed blades
Set of 6 blades (40 TPI)
Ideal for hard woods, circuit boards, non-
ferrous metals, Plexiglas and plastic.
NO 28 107 Set of fine-toothed blades
Set of 6 blades (28TPI)
For thinner materials, or finer cuts on hard
and soft woods as well as plastics (Plexiglas
and acrylics, too).
NO 28 108 Coarse toothed (16 TPI). For
Set of 6 blades hardwoods, plastics (Plexiglas and acrylics,
too) as well as thicker materials.
Standard blades with pin ends:
NO 28 740 Coarse (10 TPI). For hard and
Set of 6 blades soft woods and thick material.
NO 28 742 Fine (18 TPI). For soft and hard
Set of 6 blades woods and thinner materials.
NO 28 744 Very fine toothed (25 TPI). For v
Set of 6 blades plastics, fiberglass, non-ferrous metals,
acrylics and wood.
Spiral blades for DSH/E:
NO 28 746
Set of 6 blades Plain end blades, cutting in all directions,
eliminating the need to turn the work piece
(advantageous, especially with bigger work
pieces). A 1/16" hole is required. Ideal for
plastic, hard and soft woods.
Proxxon_BedienAnl_DSH_US_Bel 10.06.2005 14:20 Uhr Seite 15