- 6 -
Grinding belt length
13’’x
13
/
32
’’(330 x10mm)
Head can be rotated by 60°
Motor:
Voltage:
~115 V, 50/60 Hz
Belt speed
300 to 700 m/s
Characteristic noise
emission
≤
80 dB (A)
Noise level may exceed
85 dB(A) during operation.
Ear protection must be worn!
Vibration at handle
≤
2.5 m/s
2
Class II Equipment Double Insulation
Operation
Working with the unit.
WARNING!
Do not work without protective goggles and
protective mask.
1. Switch unit on at switch
2
(Fig. 2) and adjust the
speed at knob
1
in accordance with the operation.
2. The grinding surface
2
(Fig. 3) is particularly
suitable for processing plane surfaces. Curved or
round surfaces are best processed with grinding
surface
3
. Surface
1
is suitable for operations in
narrow apertures and cavities.
NOTE:
High grinding performance is achieved not by
applying excessive pressure but by employing a
correct and even belt speed. Let the belt do the work
and do not put too much pressure on the tool.
Replacing the grinding belt
WARNING!
Disconnect from the mains before replacing the
grinding belt.
1. Depress tensioning roller
1
(Fig. 4) axially towards
the drive wheel and remove grinding belt from the
drive wheel sidewards
2
.
2. First position new grinding belt around the
tensioning roller
1
. Then press the tensioning roller
backwards and position the belt over the drive
wheel
2
.
Adjusting the grinding belt
The grinding belt must run in the center of the
tensioning roller. If this is not the case, it must be
readjusted.
WARNING!
Danger of injury!
1. Switch unit on.
2. Select lowest speed.
3. Turn adjusting screw
2
(Fig. 5) to left or right until
the belt runs in the center of the tensioning roller
1
.
Adjusting the grinding head
1. Switch unit off
2. Press retaining knob
1
(Fig. 6) in and adjust the
grinding head
2
to the desired angle.
3. Release retaining knob. The grinding head
engages.
Connecting the vacuum cleaner
1. Connect parts of the connection adapter
1
(Fig. 7).
NOTE:
The adapter parts can be connected in such a way
that vacuum cleaner pipes of various diameters may
be connected.
2. Insert vacuum cleaner hose
2
into the adapter
1
.
Maintenance
WARNING !
Danger of injury!
Disconnect from the mains prior to all maintenance
and cleaning operations.
NOTE:
Each unit becomes soiled in carrying out operations
on wood. Care is therefore essential. Always keep the
apertures which are necessary for cooling the motor
free of dust and dirt. All grinding dust must be
thoroughly removed with a brush or a soft cloth.
Make certain that no ventilation slots are obstructed.
The power cord shall be replaced by part no.
38536-53 only, if the cord is damaged.
Accessories (included):
Replacement grinding belts (4 units)
For safe operation, it is recommended that only
PROXXON-accessories be used with this product, i.
e. the following:
Grinding belts 28581 (240 grit-set of 5)
Grinding belts 28583 (100 grit-set of 5)
