ENG – AlloTech HOR 2 - 4
ENG – AlloTech HOR 2 - 4
I) RECOGNIZE THE CURRENT MODE
If when pressing a key :
the LED flashes green 3 times, this remote is in BS mode
the LED stays green, this remote is in HS mode
II) PROGRAMMING IN BS MODE, FOR ALL BLACK HORMANN REMOTE
CONTROLS WITH BLACK KEYS
On receiver only
- Press the "P" button on your receiver. The LED on the receiver flashes.
- Press the button on your remote control that you wish to program for at least 3 seconds.
- The receiver LED flashes faster and goes out.
- Your remote control is correctly programmed.
III) RESET PROCEDURE
To be followed in case of wrong manipulation, in order to put the remote control back
in BS mode:
- Make a quick double click on the first button of your remote control and keep the button
pressed.
- Then, after a few seconds, the LED starts to flash, do not release the button.
- After 25 seconds, the LED goes out and then flashes red 10 seconds later.
-Release the button and press the same button again without releasing it.
- The LED flashes red, then green once, green twice, green three times. After the third
green flash, release.
- Wait a few seconds.
- The LED flashes red and green then goes out.
- Your remote control is reset.
IV) PROGRAMMING IN HS MODE, FOR ANY GREY 868 MHZ HORMANN
REMOTE CONTROL WITH BLUE KEYS
REGISTER DIRECTLY ON A NON BS HÖRMANN RECEIVER
- Press the "P" button on your receiver. The LED on the receiver flashes.
- Press the button on your remote control that you wish to program for 2 seconds.
- The LED on the receiver flashes faster and goes out.
- Your remote control is correctly programmed.
V) CHANGE THE MODE (IF YOU HAVE AN OLD HÖRMANN MODEL, IN
868 MHZ, NON-BS)
Each key can be in HS or BS mode independently of the other keys on the same remote
control.
- Press and hold the key for 35 seconds:
- The LED will remain fixed (HS mode) or flash red and green after 7 seconds (BS mode) for
25 seconds.
- The LED will turn off for 10 seconds and turn solid red.
- Release the key.
- Press the same key again: the LED is steady red and then flashes green once, then flashes
green twice.
- Release the key quickly. The LED flashes green quickly and goes out.
- After 10 seconds, the LED flashes red and green several times and goes out.
- You have changed the mode of this key.
TECHNICAL DETAILS
Power supply : 3V battery - CR2032 | Power consumption : 20 mA | Frequency : 868 MHz
DECLARATION OF CONFORMITY
We, Allotech, declare that this product is in conformity with the essential requirements and other
relevant provisions of Directive 1999/5/EC. (TR2)
A declaration of conformity is available at www.allotelecommande.com. Failure to comply with these
instructions will exclude Allotech's liability and warranty. Allotech shall not be liable for any changes
in standards and norms after the publication of this manual.
DISTRIBUTEUR
DISTRIBUTOR
VERTEILER
ALLOTECH
SILVER STONE MONACO
12 RUE DE MILLO,
98000 MONACO (MC)
PRODUCTEUR
PRODUCER
FABRIKANT
PROXIMA SP.J. 87-100
TORUŃ, UL. POLNA 23A
