MP.11 and MP.11/a Quick Install Guide
Chapter 3. Management Overview
13
4. Press down on the cable cover lock to release the cable cover .
5. Remove the cable cover from the unit.
6. Remove the front and back covers from the unit.
7. Place the back cover on the mounting location and mark the center of the three mounting holes.
8. Remove the cover from the wall and drill a hole at each of the locations you marked. Each hole should be
wide enough to hold a mounting plug (6 mm x 35 mm).
9. Insert a plug into each hole.
(Four 6 mm x 35 mm plugs are provided; you need to use only three of these for wall mounting.)
10. Insert a screw into each of the mounting holes molded into the back cover.
(Four 3.5 mm x 40 mm pan-head screws are provided; you need to use only three of these for wall mounting.)
11. Insert the screws into the wall plugs; use a screwdriver to tighten the screws and attach the back cover to the
wall.
12. Attach Ethernet and power cables to the MP.11/a unit, as necessary.
13. Snap the unit into the back cover, replace the front cover, and replace the cable cover.
14. Turn on the MP.11/a (see “Switching On the Indoor MP.11/a”
on page 14
).