SCSI to SCSI RAID Subsystem
User Manual
45
Chapter 5 Configuration Utility Options
The subsystem has a built-in setup configuration utility containing important information
about the configuration as well as settings for various optional functions in the
subsystem. This chapter explains how to use and make changes to the setup utility.
Configuration Methods
There are three methods of configuring the subsystem:
• VT100 terminal connected through the controller’s serial port
• Front panel touch-control keypad
• Web browser-based proRAID Manager GUI
IMPORTANT: Only one method can be used to configure the
subsystem. Two methods can be used at the same time but the
other method will be in read-only mode.
5.1 Configuration through a Terminal
To start-up:
1.
Connect a VT100 compatible terminal or a PC operating in an equivalent terminal
emulation mode to the monitor port located at the rear of the subsystem.
NOTE: You may connect a terminal while the subsystem’s power is
on.
2.
Power-on the terminal.
3.
Run the VT100 program or an equivalent terminal program.
