ENGLISH
19
Cleaning Your Cricut Create
™
Machine
WARNING! Always unplug your Cricut Create machine before cleaning.
To clean the Cricut Create machine, gently wipe exterior panels with a damp cloth.
Immediately dry any excess moisture with a chamois or other soft cloth. Do not use
chemicals or alcohol-based cleaners (including, but not limited to, acetone, benzene,
and carbon tetrachloride) on the machine. Abrasive cleansers and cleaning tools
should also be avoided. Do not immerse the machine or any component of it in water.
Additional Basic Care Tips:
• Keep away from food and liquids
• Keep in dry, dust-free location
• Avoid excessive heat or cold
• Do not leave in car, where excessive heat may melt or damage plastic parts
• Do not expose to direct sunlight for any extended period of time
Frequently Asked Questions
TIP: For our complete list of frequently asked questions, plus the latest updates to the
User Manual, visit www.cricut.com.
Q: Do I have to hold down the
Shift
key to use it?
A: No. Just press it once and it will be backlit in green, indicating it is in use.
Q: Are the Creative Feature keys the same for each cartridge?
A: Only the
Shadow
feature is found on most sets. The other five Creative Features are
handpicked by the artist and will vary.
Q: How long will the blade last?
A: Anywhere from 500 to 1500 single cuts, depending on what kind of materials you
are cutting. Replacement blades are inexpensive and easy to change. Refer to the
“Replacing the Cutting Blade” section on page 19 in this manual.
Q: How long will a cutting mat last?
A: Each mat will last anywhere from 25–40 full mat cuts, depending on the size of cuts
and what kind of materials you are cutting. We recommend that you use several mats,
rotating them often. This will extend the overall life of each mat.
Q: Can I use a smaller paper size than the size of the cutting mat?
A: Absolutely! Just align a corner of the smaller paper with the bottom left corner of
the mat, even in the
Portrait
mode. Once the mat is loaded, use the Blade Navigation
Buttons to move the cutting blade down to the upper right corner of the new paper.
Then press the
Set Paper Size
key on the keypad overlay to let the machine know
where to start cutting on the new size of paper.
Q: Do I have to finish cutting a full page before unloading the cutting mat?
A: No. You can unload the paper and remove just the pieces you need. You can then
reload the paper at a later time and navigate the cutting blade to any open area to
resume cutting. If you immediately use the same paper for a new cut, press the
Load
Last
key instead of the
Load Paper
key. The
Load Last
key will automatically return the
cutting blade to the place where it stopped cutting.
Q: How does the
Paper Saver
mode work?
A: The
Paper Saver
mode will “pack in” any selected cuts to optimize the space
needed. See page 13
of this manual.
