System connection
① Use one camera and one monitor
② Use Several Cameras and one Monitor
7
8
BNC
BNC
DC 12V
Monitor
Monitor
MULTIPLEXER
Video Divider
DVR
VCN
SN
Video Control
Power Supply Control
1
+12V DAMP-
2
NC DAMP+
4
GND DRIVE-
3
VIDEO DRIVE+
Equip with automatic aperture lens. The definitions of the pins of the
control cable are as follows (e.g. Tail Plate Sketch)
Automatic Aperture
(b) If the Lens is VIDEO driven, then the switch "DC/VIDEO"
②
should be switched to VIDEO position.
⑸
Plug the power supply
(a) Case model B- direct plug is used and after connecting
the plug "Power Indicator Light" ⑦ is on, at this point the
monitor displays the images taken.
(b) Case model D/H- power is connected by two wires.
Make sure you plug the power in the right direction "+" / "-".
(6)
Adjust the zoom and the focus of the Lens to get your
optimal image.
⑺
Back Focus-
Back Focus is adjusted when the camera leaves the factory;
therefore, no more adjustment is needed.
However, in case you can't reach optimize focus by the lens
focus ring, untie the "Back Focus Screw", then turn the
"Lens Mount Ring" clockwise or counter clockwise until the
image is clear. Then retighten the "Lens Mount Screw".
EN
EN
