Protocol ROVER GX, Инструкция по эксплуатации

Страница: 9 / 28

REMOTE BATTERY AND PHONE INSTALLATION
CHARGING THE CAR BATTERY
1. Make sure the car is turned off.
2. Remove the battery from the battery compartment.
3. Connect the USB charging cable to the battery.
4. Plug the charger into a USB port. The USB light will turn red while charging
and will turn off once fully charged.
5. Plug the battery back into the car and close the battery compartment..
Charging time: 150 minutes --- Drive time: approximately 25 minutes
CAUTION WHEN CHARGING
1. When charging, place product on a dry, well-ventilated surface and keep
away from heat sources.
2. Always use adult supervision while charging.
3. In order to increase battery longevity, avoid repeat charging and
excessive discharging.
4. As battery temperature is high immediately after driving, charge after cooling
down for higher efficiency.
5. Do not strike or subject battery to hard impacts or sharp surfaces.
6. Do not use another charger than that which is supplied with this item.
7. Do not use or leave battery near a heat source such as fire or space heater;
exposure to heat may result in reduced performance or in some cases
dangerous conditions.
8. If battery is left in charging state for an extended period of time after being
fully charged, the battery may automatically discharge.
9. Never leave the battery unattended during charging.
10. Do not disassemble battery.
11. Do not submerge battery in water.
5
DO NOT CHARGE OVERNIGHT OR BEYOND
THE CHARGING TIME STATED. DO NOT LEAVE BATTERY UNATTENDED.
*Battery: Li-ion, 3.7V, 500mAh
If you purchased extra batteries, allow the engines to cool between uses
in order to prolong engine life.