Protocol OCEANA, Инструкция по эксплуатации, Страница: 5 / 11

REMOTE BATTERY INSTALLATION
1. Install batteries carefully.
2. Do not mix old and new batteries.
3. Do not mix different types of batteries.
Remove battery cover from controller. Insert 6 x ‘AA’ batteries according to
indicated polarities. Replace and screw back in battery cover.
CHARGING THE DRONE BATTERY
1. Pull up the rubber, waterproof cover to the charging jack.
2. Plug the connecting wire into the jack and connect to the charging pack.
The connecting wire may be pre-connected.
3. Plug the charging pack into an outlet. The red light on the pack will turn on
while charging and turn off once charged.
4. Remove the wire and pack from the drone and replace the waterproof cover
making sure it is secure.
Charging time: 120 minutes --- Flying time: approximately 7 minutes
CAUTION WHEN CHARGING
1. When charging, place product on a dry, well-ventilated surface and keep
away from heat sources.
2. Always use adult supervision while charging.
3. In order to increase battery longevity, avoid repeat charging and excessive
discharging.
4. As battery temperature is high immediately after flight, charge after cooling
down for higher efficiency.
5. Do not strike or subject battery to hard impacts or sharp surfaces.
6. Do not use any other charger than that which is supplied with this item.
7. Do not use or leave battery near a heat source such as fire or space heater;
exposure to heat may result in reduced performance or in some cases
dangerous conditions.
8. If battery is left in charging state for an extended period of time after being
fully charged, the battery may automatically discharge.
9. Never leave the battery unattended during charging.
10. Do not disassemble battery.
11. Do not submerge battery in water.
DO NOT CHARGE OVERNIGHT OR BEYOND THE CHARGING TIME STATED.
DO NOT LEAVE BATTERY UNATTENDED.
*Battery: Li-Po, 7.4V, 1200mAh
If you purchased extra batteries, allow the engines to cool between flights
in order to prolong engine life.
5 4
*Low Battery Signal: The
lights on the drone will begin
to flash and the controller
will beep during flight to
indicate low battery.