Protocol Dronium Two AP, Инструкция по эксплуатации

Страница: 9 / 15

OPERATION (MODE 2)
Pull the throttle left or right,
the drone banks to the left or right.
Push the direction lever up or down,
the drone flies forward or backward.
OPERATION (MODE 2)
12
13
STARTING THE ENGINE; ENGINE IDLE
1. After synchronizing the drone, gently push the throttle up and release
to go into idle mode.
OR
2. Pull the throttle and direction sticks to the center at the same time and
release to go into idle mode. The blades will rotate but the drone will
not lift.
TAKE-OFF
1. Gently advance the throttle up to a desired height and release. The drone
will hover at that height.*
LANDING
1. Push down on the throttle until the drone is on the ground.
FIRST TIME FLYERS!!! TAKE YOUR TIME! GO SLOW!
Practice hovering until you are comfortable with flight before attempting
any other maneuvers. Make small movements letting the stick return to the
center. If you start to lose control, don’t panic. Just press land.
Pull the direction lever to the left or right,
the drone turns to the left or right.
NOTE:
- The engine will shut off if you choose to hold the throttle down for
3 seconds.
- Emergency Shut Off: When in flight,
pull the throttle and direction stick
to the center at the same time and
the drone will shut off.
* The drone may drift a bit, especially in the first 30 seconds until the
altitude sensor gets a good fix on the position. Some drift is normal.