Protocol DOT VR, Инструкция по эксплуатации, Страница: 16 / 21

RE-CALIBRATING THE ALTITUDE SENSOR
If the drone crashes and after re-starting and trimming, it still is unstable, you
have the option to re-calibrate the drone.
1. Turn on the drone and then the remote and sync.
2. Push and hold the throttle and direction sticks to the lower outer corners.
3. The lights will flash to indicate that the drone has re-calibrated.
TROUBLESHOOTING
POSSIBLE CAUSE SYMPTOM POTENTIAL SOLUTION
Dot VR
does not
respond
1. Communication between
controller and aircraft was not
synchronized during set up
2. Battery power depleted on
aircraft, controller or both.
1. To synchronize, turn on aircraft
first, place it on level ground, and
then turn on controller.
2. Charge aircraft and/or replace
batteries in controller.
Response to
control inputs
intermittent or
erratic
1. Controller battery power
nearly depleted.
1. Replace batteries in controller.
Dot VR
will not hover
or strafe
correctly
1. The aircraft was not
on level ground during
synchronization.
2. Trim settings are incorrect.
1. Re-synchronize aircraft and
controller.
2. Reset the trim buttons on the
controller and re-trim flight controls.
*Allow 15 minutes to pass between full flights as this will give the motors a chance
to cool down. Failure to do so could wear out and shorten the life of the motors.
HOW TO CHANGE THE BLADES
- All drones have two rotors that spin clockwise and two rotors that spin
counter-clockwise.
-
Make sure to place the blades on the correct axis or they will not spin
correctly and the drone will not lift.
- Each blade is marked with A or B. There may be a number after the
letter but you can ignore the number.
- Make sure to follow the graphic below to see where to place the blades.
CAMERA/FRONT
A B
A B
12