Proteus PEC-1900 Series, Руководство пользователя

Страница: 4 / 8

- 3 -
MAGNETIC CYCLE ASSEMBLY INSTRUCTION
IMPORTANT : READ ALL STEPS BEFORE ATTACHING PEDALS
Step 1 . Attach both front and rear stabilizers ( 2/3 ) to main frame ( 01 ), fix with carriage bolts
( 27 ) washers ( 30 ) and dome nuts ( 34 ).
Step 2.
a. Attach pedals ( 18 / 19 ) to pedal cranks, ( pedals marked "L" and "R" indicates left
and right side of bike. Make sure not to mix it up ).
b. Left pedal has left hand thread and must be turned counter- clockwise ( ccw ) to
attach, right pedal has right hand thread, must be turned clockwise ( cw ) to attach.
Step 3. Attach saddle ( 13 ) to saddle plate of seat post ( 04 ) fasten with spring washers ( 32 )
and nylon nuts ( 33 ).
Step 4. Attach seat post ( 04 ) to seat post support ( on main frame ), adjust saddle to desired
height and tighten with knob ( 14 ).
Step 5. Insert tension cable ( 10 ) inside of handle bar post ( 05 ), pull the tension cable out
from middle hole of handle bar post. Connect wire A ( 11 ) and wire B ( 12 ), then
attach handlebar post to main frame ( 01 ), fix with bolts ( 28 ) and washers ( 30 ).
Assemble tension control knob ( 09 ) and tension cable ( 10 ), by connecting cable head
( on knob ) to the draw hook of tension cable ( please refer to
FIG. A & FIG. B ).
Assemble the tension control knob ( 09 ) onto handlebar post ( 05 ). Note the fix-hook
(on tension control ) well inserted onto handle bar post. Then tighten with screw ( 26 ).
Assemble handlebar & monitor
( 1 ) If your model no. is PEC-1900/1900EP/1905/1905EP/1925HP, please do
step 6. &
step 7.
( 1 ) If your model no. is PEC-1900GP/1905GP/1935GP. please do step 8.
Step 6. Assemble foam grip ( 17 ) and end cap ( 16 ) onto one side of handlebar ( 06 ), then
attach handlebar ( 06 ) to handle bar post ( 05 ), tighten with washer ( 31 ) and T-knob
( 25 ). Assemble foam grip ( 17 ) and end cap ( 16 ) onto another side of handlebar
( 06 ).
Note : Use some soap water as lubricant while fitting foam grips.
Step 7. Assemble wire A ( 11 ) to monitor ( 08 ), then attach monitor on fixplate of handlebar
post.