© 2017, Obelis S.A Registered Address:
Bd.Général Wahis, 53, 1030 Brussels, Belgium
4
Assembly
1. Align holes in the upper housing with the 2
holes in the handle.
2. Insert screws and tighten firmly.
Operation
1. Position the fan heater so that it stands upright
on a firm, level surface and at a safe distance
from wet environments and flammable objects.
2. Connect the fan heater to the proper electrical
power.
3. Set the thermostat dial to the maximum
temperature.
4. The fan heater will switch on when the function
selector dial is set to one of the three power
settings.
5. Once the room reaches the desired
temperature, turn the thermostat dial back
until heating element turns off.
Automatic Overheat Safety Control
– This heater is equipped with safety internal
heat limiting thermostat and overheat
protection circuit. When a potential overheat
temperature is reached, the system will
automatically shut the heater off.
Thermostat Instructions
– At first, set the thermostat to “+” and let the
heater operate with full power input. When
the room temperature reaches the required
value, turn the thermostat to the left until it
switches off.
– The thermostat will then switch on and off
automatically to control the room temperature
according to the preset value and keep the
room temperature constant.
– When using the heater for the first time, you
may notice a slight emission of smoke. This
is quite normal and it stops after a short
time. The heating element is made of steel
and was coated with a layer of protective oil
during production. The smoke is caused by
the leftover oil as it is heated.
Cleaning and Maintenance
– Before cleaning the appliance, disconnect it
from the outlet and let it cool down.
– The enclosure is easy to get dirty. Wipe it
often with a soft sponge. For very dirty parts,
wipe with a sponge dipped in < 50°C water
and mild detergent, then dry the heater
enclosure with a clean cloth. Be careful not to
let the water enter the inside of the appliance
– In order to protect the enclosure, don’t
splash water onto the heater, and never
use a solvent like gasoline, isoamyl acetate,
toluene, etc. to clean the heater.
– When you store the heater, let it cool down
first and, keep it dry. Then cover it with a
plastic bag, put it in the packing box and
store it in a dry, ventilated place.
Setting
Function
Unit is Off
Fan Runs - No heating
Fan Runs - Quarter Power Heating
Fan Runs - Half Power Heating
Fan Runs - Full Power Heating
NOTE
: PT-03-230-EU / PT-033-230-EU / PT-
05-400-EU / PT-09-400-EU, the fan will run
continuously while the heater is operating.
NOTE:
PT-02-230-EU the fan will shut off when
desired temperature is reached. Fan will not run
continuously.
NOTE:
This chart does not apply to all models.
Check your heater for appropriate symbols.
Operation
