INSPECTION
Before each use of Personal Protective Equipment (PPE) it is obligatory to carry out a pre-use check of the equipment, to ensure
that it is in a serviceable condition and operates correctly before it is used.
During pre-use check it is necessary to inspect all elements of the equipment in respect of any damages, excessive wear,
corrosion, abrasion, cutting or incorrect acting, especially in rescue lifting devices - cable (wires, clips, ferrules, loops, thimbles,
connectors, adjusting elements) and automatic brake proper acting, casing, energy absorber (attaching loops, connectors),
connectors (main body, rivets, gate, locking gear acting).
PERIODIC INSPECTION
After each 12 months of utilization the rescue lifting device must be withdrawn from use to carry out manufacturer's detailed
inspection. The inspection must be carried out by the rescue lifting device manufacturer or his certified representative only.
During this inspection will be established admissible time of the device use till next manufacturer's inspection.
The result of inspection must be recorded in Identity Card.
Regular periodic inspections are the essential for equipment maintenance and the safety of the users which depends upon the
continued efficiency and durability of the equipment.
During periodic inspections it is necessary to check the legibility of the equipment marking.
It is essential for the safety of the user that if the product is re-sold outside the original country of destination the reseller shall
provide instruction for use, for maintenance, for periodic examination and for repair in language of the country in which the
product is to be used.
WITHDRAWAL FROM USE
Personal protective equipment must be withdrawn from use immediately when any doubt arise about its condition for safe use
and not used again until confirmed in writing by equipment manufacturer or his certified representative after carried out the
detailed inspection.
WITHDRAWAL FROM USE AFTER ARREST A FALL
Personal protective equipment must be immediately withdrawn from use when it has been component of equipment used to
arrest a fall. After that the detailed manufacturer's inspection must be carried out.
Detailed manufacturer's inspection can be carried out by:
- equipment manufacturer;
- or person recommended by manufacturer
- a company recommended by manufacturer.
During this inspection will be established if the device can be longer used and will be define the admissible time of device use till
next manufacturer's inspection. If the device can not be longer used it will be subjected to destroyed.
TRANSPORTATION
PPE must be transported in the package (e.g. bag made of moisture-proof textile or foil bag or cases made of steel or plastic) to
protect it against damage or moisture.
MAINTENANCE AND STORAGE
PPE can be cleaned and desinfected without causing adverse effect on the materials in the manufacture the equipment. For
textile products use mild detergents for delicate fabrics, wash by hand or in a machine and rinse in water. Plastic parts can be
cleaned only with water. When the equipment becomes wet, either from being in use or when due cleaning, it shall be allowed to
dry naturally, and shall be kept away from direct heat. In metallic products some mechanic parts (spring, pin, hinge, etc.) can be
regularly slightly lubricated to ensure better operation.
PPE should be stored loosely packed, in a well-ventilated place, protected from direct light, ultraviolet degradation, damp
environment, sharp edges, extreme temperatures and corrosive or aggressive substances.
6/8
