4
WARNING: Always wear safety glasses and other
necessary protective devices or apparel when installing
or working with anchor bolts.
CAUTION: Not recommended for use in lightweight
masonry such as block or brick.
CAUTION: Use of carbide drill bits manufactured within
ANSI B94.12-77 drill bit diameter requirements is
recommended for installation of this anchor bolt. Use of
core drills is not recommended to drill holes for use with
this anchor.
CAUTION: Not recommended for use in new concrete which has not had sufficient time to cure.
WARNING: User must read and follow the supplied instructions (or instructions supplied with non-supplied equipment) for
the associated equipment used in this kit (i.e. full body harness, shock absorbing lanyard with attached rope grab, and
rope lifeline). Failure to read and follow all instructions could result in serious or fatal injury.
IMPORTANT: For special (custom) versions of this product, follow the instructions herein (i.e. Compliance in a Can). If
enclosed, see attached supplement for additional instructions to be followed when using a customized product. If instructions
for any component of the system are missing or unusable, contact PROTECTA for a replacement set before use.
3.14 MAKING CONNECTIONS: When using a hook to make a connection, be certain accidental disengagement (rollout)
cannot occur. Rollout occurs when interference between a hook and the mating connector causes the hook’s gate
or keeper to accidentally open and release. Self-locking snap hooks and self-closing and locking carabiners must
be used to reduce the possibility of rollout when making connections. Do not use hooks or connectors that will not
completely close over the attachment object. Never use non-locking snap hooks. Follow supplied instructions for
each system component.
3.15 CONNECTING TO THE CONCRETE ANCHOR: Connection to the installed concrete anchor may be made using a
self locking snap hook or self closing carabiner ONLY. Do not use a knot to connect a lifeline to the concrete
anchor. Do not pass lanyard or lifeline through the anchor ring and hook back into lanyard or line. When
connecting, make sure connections are fully closed and locked. When using a shock absorbing lanyard (SAL),
ensure that the shock absorber end of the lanyard is connected closest to the dorsal D-ring of the harness (does
not apply to “Compliance in a Can” kit as the SAL is permanently attached to rope grab). If using a self retracting
lifeline, make sure device is properly positioned so that retraction is not hindered. Always protect lifeline/lanyard
from contact against sharp edges or abrasive surfaces. Make sure all connections are compatible in size, shape,
and strength. Never connect more than one personal fall arrest system to any single concrete anchor at a time.
WARNING: User must read and follow the supplied instructions (or instructions supplied with non-supplied equipment) for
the associated equipment used in this kit (i.e. full body harness, shock absorbing lanyard with attached rope grab, and
rope lifeline). Failure to read and follow all instructions could result in serious or fatal injury.
IMPORTANT: For special (custom) versions of this product, follow the instructions herein (i.e. Compliance in a Can). If
enclosed, see attached supplement for additional instructions to be followed when using a customized product. If
instructions for any component of the system are missing or unusable, contact PROTECTA for a replacement set before use.
1. Drill and clean
hole.
2. Drive assembled
bolt into hole.
3. Tighten to
appropriate torque.
Figure 3 - Installing Anchor Bolts
Содержание AJ720A
Страница 6: ...6 Anchor Plate Anchor Bolt 7 3 DIMENSIONS ...
