Performance Note
• All fog machines develop condensation around the output nozzle, this may result in some
moisture accumulation on the surface below the output nozzle. Please consider this when
installing your unit.
• All fog machines may sputter small amounts of fog occasionally during operation and for a
minute or so after being turned off.
• All fog machines have a recycling period after long bursts when the machine will shut itself down
for a short period in order to heat up again. During this time no fog can be produced.
Maintenance
Do not allow the fog ? uid to become contaminated. Always replace the cap on the fog ? uid
container and the fog machine liquid tank immediately after ? lling.
All fog machines are prone to clogging due to the thick consistancy of fog liquid and the high
temperature at which it vaporizes. However, a properly maintained fog machine should provide
years of reliable use.
DMX Settings
Channel A
The V-Fog uses 1 channel to control smoke output. This channel has a value range of 0-255.
Timer functions such as duration and interval can be programmed using the DMX controller or
DMX control software.
If channel A has a value from 0 to 5, the unit is OFF
Between the values 6 to 249, the volume of fog output is regulated.
With 6 being the minimum
amount of fog produced and 249 approaching the maximum. The fog output rises as the DMX
value is increased.
If Channel A has a value from 250 to 255, the machine will operate at maximum output.
Note:
In the example above, if the machine were assigned the DMX address of 124, Channel A
would correspond to DMX address 124
250-255
6-249
0-5
250-255 = Maximum Smoke Output 100%
6-249 = Smoke Output (5% - 95%)
0-5 = OFF
V
-Fog
www.ProTech-Lighting.com
English
