10
MARK76R0001 Rev 3
Installation can present a Danger with electrical shock or burns, only authorized personnel
should install the equipment. Initial installation should be done by a ProSun certified
technician. As the equipment owner it is your responsibility to ensure that correct electrical
requirements are met and followed.
Overheating can occur if proper ventilation is not followed. Never obstruct the airways in the
inflow and outflow areas. If proper ventillation is not followed system malfunction and damage
may occur. Always install the unit at proper distance from walls in order to have proper airflow.
Failure to do so may cause system failures or errors.
The customer is responsible for all costs associated with the preparation of the installation
of the equipment. This includes but is not limited to room preparation, costs, fees, permits,
and inspections unless specified otherwise in the sales order for the equipment purchased.
ProSun and all authorized parties shall reserve the right to refuse to install equipment into any
room which has not been properly prepared in accordance with the electrical specification and
room requirements.
The electrical contractor or his designee shall provide and install all electrical material as
specified for a safe operating system. ProSun certified technicians will not perform any
electrical work. The recommended electrical plan must be coordinated between the customer
and the electrical contactor. Any deviation of the electrical, before, during and after equipment
installation is the responsibility of the customer. The electrical contractor or his designee shall
ensure the completion of all electrical requirements prior to the installation of any ProSun
equipment. All wires shall be single solid runs without splices, meeting NEMA standards.
The electrical contractor or his designee should ring out, tag and terminate all wires at both
ends. Each should be inspected to ensure that no wires have been grounded or are left
open. ProSun certified technicians are not responsible for the final installation of the electrical
system, the electrical contractor or his designee should be present to make the final electrical
connection upon completion of the installation of the equipment.
The customer shall bear the sole responsibility for compliance with all applicable codes,
OSHA, NEMA, local and national Standards. All electrical work shall conform to the
requirements of the national electrical code, OSHA or applicable local and or state
ordinances.
WARNING:
Position the equipment so that disconnection to the mains plug can be easily
made during the unexpected error which could lead to a hazardous situation. Be careful not to
trip over the power supply cord.
WARNING:
Power supply cord must be replaced by ProSun certified technician.
WARNING:
Inspect equipment for any obvious physical damage before use.
DANGER!
WARNING!
WARNING!
WARNING!