Prostat PFK-100, Руководство пользователя

Страница: 11 / 28

11
Rev. 6 / July 16, 2020
PFK-100 Field Meter Set
F. PCS-730 Charging Source Prepara on for Use
1. Install provided 9 volt ba ery by sliding ba ery com-
partment open and fi rmly snapping ba ery terminals to
the appropriate connectors. Ba ery can only be con-
nected in one way. Carefully re-close the ba ery com-
partment.
2. Before opera ng the CPM-730, the operator should
select and wear a fully func onal wrist strap that is
properly grounded.
3. Mount the CPM-720A Charge Plate Assembly to the
PFM-711A Field Meter as described above.
4. Install the charging Wand male banana snugly into the female receptacle located at the front
of the PCS-730’s case.
OPERATIONAL REQUIREMENT
Both cases of PFM-711A Field Meter and PCS-730 Charging Source must be grounded.
In addi on, the PCS-730 Charging Wand MUST be fully seated in the output receptacle
for proper opera on.
5. With the operator’s fi ngers contac ng the grounding snap on the back of the PFM-711A unit,
slide the three posi on ( kV/inch, OFF, V/inch ) RANGE/POWER switch (S1) to the kV/inch posi-
on.
a. Confi rm that the instrument’s display is ac vated and that the ba ery low indica on
( BATT ) is not displayed. If low ba ery indica on is displayed, replace the ba ery.
b. Hold the PFM-711A/CPM-720A combina on away from surfaces and objects, and rotate
the PFM-711A’s Black Panel ZERO knob (r16) un l the display indicates 0.00.
6. With the operator’s fi ngers contac ng the metal grounding snap on the back of the PCS-730
Charging Source, press the three posi on rocker switch to the front, +1kV posi on. Touch
the p of the charging wand directly to the upper sensing plate of the CPM-720 Charge Plate