Quick installation Guide
http://www.prostart.org
P.3
PROGRAMMING THE TRANSMITTER TO THE MODULE
1.
In programming mode (page 3)
- the parking lights will stay on for up to 20 seconds.
2.
Before the lights go out, turn the ignition key to OFF (if not OFF already), then ON, then OFF.
3.
Press and hold the
button until the parking lights flash
5 times quickly
(unit will click).
4.
The transmitter has been stored in memory. Each unit can store 4 remotes in its memory.
5.
You have 20 more seconds to select one of the sub-menus if needed.
To program a transmitter on the second vehicle for multi-car operation;
press the
button (instead of
) in step 3 of the transmitter association procedure.
ENTERING PROGRAMMING OPTIONS
1.
In programming mode (page 3)
the parking lights will stay on for up to 20 seconds.
2. Before the lights go out, press and hold the brake pedal and then press one of the following buttons.
x
LOCK
to access mode 1;
x
UNLOCK
to access mode 2;
x
TRUNK
to access mode 3
3. The parking lights will flash 1, 2 ou 3 times to confirm entry into a mode.
4. Release the brake pedal.
Once the desired mode has been selected, the unit will fall (by default) into function #1 of that mode; you can
now select the option you want in function 1. Once this option has been chosen, the unit will move on to
function 2 of the mode selected, and so on.
x
LOCK
to access option 1;
x
UNLOCK
to access option 2;
x
TRUNK
to access option 3;
x
START/STOP
to access option 4.
5. After the programming of any mode is completed, the parking lights and the LED on the antenna will turn
ON for 20 sec. During those 20 seconds, select one of the sub-menus if needed.
PROGRAMMING OPTIONS
MODE 1
* INDICATES DEFAULT SETTING
FUNCTION 1 – Ignition-controlled door locks
OPTION 1*
Ignition lock DISABLED
OPTION 2
Ignition lock
ENABLED
FUNCTION 2 – Secure Lock
OPTION 1*
Secure lock DISABLED
OPTION 2
Standard secure lock
ENABLED
FUNCTION 3 – Starter Kill
OPTION 1*
Passive arming (60 sec.)
Entering programming mode using the
Hood Pin
Entering programming mode using the
A.P.B. (Optional)
x
Press and hold the hood pin down for 4 seconds.
x
Make sure the hood is closed.
x
Release the hood pin.
The parking lights will turn
ON
for 1 second.
x
Turn the ignition key to the
IGNITION ON (RUN)
position.
x
While the parking lights are
ON
, press the hood pin
once more and release immediately.
The parking lights will turn
ON
and stay
ON
for
20 seconds. You now have 20 sec. to select a
submenu.
x
Within 5 seconds, press the programming button
on the antenna twice for 1 second each time.
The LED will come
ON
solid for 20 sec.
x
You now have 20 seconds to select one of the
sub-menus.
Note 1:
To exit programming mode, close the hood.
Note 1:
To exit programming mode, press on the
antenna button once (the LED will come
ON
) and
release.
Note 2:
For vehicles that require the ignition to be turned
ON
to activate the brake circuit, follow these steps to
select a submenu:
x
After flashing the hood, turn the ignition
ON
and wait for the parking lights to come
ON
. Then,
press the brake pedal to access the sub-menus.
