3
Filling in Water
•
You must fill in water before turning on the foot spa. Never
try to operate this spa without water in the bucket.
•
Filling in water with a water bucket or a clean pot. Do not
have your spa under faucet directly to fill water.
•
Be careful NOT to spill water on the control panel.
•
To speed up water heating, you can fill in warm water but
the warm water temperature shall be lower than 104F.
Water Level:
•
It is recommended to fill in water up to 50%-60% (just
about over half full) of the entire bucket.
•
The maximum water level is 70% of the water container.
•
Total not exceeding 4 Gallons of water. It'll affect the water
jets surfing function
•
Plug in power cord to the power outlet.
4
ON/OFF
•
Press ON/OFF button once to turn on power, the two-digit
LED display immediately shows the current water
temperature inside the water container.
•
The default spa massage time is 30 minutes once the power
is turned on. (Figure 1). You can use
Timer
to increase spa
massage time (up to 60 minutes).
•
The default maximum water heating temperature is
95
℉
once the power is turned on.
•
Heating
function is ON automatically if the current water
temperature is lower than its default 95
℉
.
