3.9 Moisture in Display
3.9.1 Water seen inside display after washing the mounting area
Radio is not designed to withstand pressurized streams of water. When rinsing the radio or around the radio,
a very low pressure spray is recommended.
Monitor the display for possible evaporation without harm to the radio.
Monitor the radio for strange or erratic behavior. If the issue persists, internal damage has occurred – seek
to repair or replace.
3.9.2 Slight fog after operation
– normal in colder weather. Allow radio to run for 1-2 hours; this will burn off
moisture.
3.9.3 Heavy condensation
The condensation may evaporate without harm to the radio. See “slight fog after operation.”
Monitor the radio for strange or erratic behavior. If the issue persists, internal damage has occurred – seek
to repair or replace.
3.10 Bluetooth Won’t Work
ATTENTION: PLEASE SEE OUR PAIRING GUIDE ON THE PRV-175 FOR THE MOST POPULAR BLUETOOTH DEVICES HERE
3.10.1 Bluetooth Won’t Pair
Make sure your Bluetooth device is turned on and set to PAIR first
Make sure the JBLPRV-175 is on BT MUSIC. Hold down the MODE/SEL button until BT PAIR appears. Then,
select the PRV-175 on your Bluetooth device.
Note:
It might require multiple pairing attempts before the
radio pairs.
Turn all other Bluetooth devices off so the radio doesn’t get confused with what Bluetooth device to pair to.
Turn the pairing on the Bluetooth device first before pairing is turned on the radio.
Reboot your Bluetooth device.
Turn off the Wi-Fi on your Bluetooth device.
Reset your radio using the reset procedure in 4.
Try with another Bluetooth device.
If your Bluetooth device will not reconnect, check your PO on the radio for
AL01543814
. If you have this
PO, please contact us for a software update.
Initiate warranty claim if nothing above works.
Note
: Bluetooth will only work with Bluetooth streaming in but not out. This means that phones can stream
Bluetooth music in, but Bluetooth headphones that stream out will not work.
3.11 Extra yellow wire on 12 pin wire harness
Since the PRV175 has an auto memory, the radio doesn’t need a yellow memory wire and therefore, does
not have a connection for it.
4
Reset Procedure
Power the radio off. Then press
TUNE BACK
, and then
TUNE FORWARD
in
rapid succession
3 times each.
The radio will then show
SYS CLR
.
Note: this will clear the presets.
Disconnect the 12 pin connector plug from the power and ground for 30 seconds.
