Pro'sKit SS-331, Руководство пользователя

Страница: 6 / 16

5
4.
In the high temperature, the solder waste will get oxidized(lead free solder’s
melting point is 220° C, non-lead fr
ee solder’s melting point is 180° C),swelled
and stuck on the inner wall tightly, If it did not clean after use, the solder waste
will block the desoldering gun, can not remove even use cleaning pin.
( Cleaning pin)
Please follow below steps to remove the solder waste:
1. Push the knob up, and then pull the back holder.
2. Take the spring out from the glass tube ,then remove the solder waste
Put the spring back to glass tube, then put glass tube back to position.Press the
back holder, then the knob will bullet down and become locked automatically .
INSTRUCTIONS:
1. After each operation is finished, please idling suck the desoldering gun3-5 times
soon, this can clean the solder waste inside the pipe.
2. If the operation interval is about 20 minutes, after idling sucking the desoldering
gun, please also use the cleaning tool to clean the pipe.
3. When you find the desoldering efficiency gets down, please use the cleaning
Pin to clean the pipe immediately.
4. If the operation interval is long, we advise to adjust the temperature to about
200° C . When you use it again, you can adjust to the working temperature,
5. When the glass tube has absorbed about 1/2 solder waste, please clean it
immediately. When you find the filter is getting hardened, please replace the
filter immediately.
filter
Aluminum piece Glass tube Filter