TO ASSEMBLE THE UMBRELLA
Step 1
: Remove the cap on the finial (B), and connect with the solar panel (A).
And then attach them to umbrella. Keep the cap for future use.
Step 2:
Have the umbrella securely fastened into an umbrella base.
(Base not included)
The batteries will be fully charged after 8 hours of sunlight or 5-6 hours using
the AC adapter.
MAKE SURE THE LED LIGHTS ARE OFF FOR THE SOLAR PANEL TO
RECHARGE THE BATTERY.
CAUTION:
YOU MUST CHARGE BATTERY BEFORE FIRST USE .
Please note that battery can discharge if they are left unused
or uncharged for a long period of time. Failure to charge the battery
will result in premature dimming of the lights in your solar umbrella.
OPEN
CLOSE
OPEN
CLOSE
B
B
A
2
3
NOTE:
The Finial (B) contains two lithium batteries (2 x 2200mAh). Do not
attempt to open the Finial (B) when in use
If batteries are not working properly, please
contact customer service to replace the entire finial. Do not attempt to replace
the batteries.
. Do not use the Umbrella without
the Finial (B) properly installed.
AC Adapter:
Input: 100V~240V AC, Output: 4.2V DC
AC adapter can be used for both indoor and outdoor.
UL Cer
CAN ICES-3(B) / NMB-3 (B)
tification number is: E486164.
TO OPEN THE UMBRELLA
Before opening your umbrella, gently pull apart and separate
the ribs into their natural open position.
Pull down the rope until you see the lower hole or upper hole
on the tilt, then insert the pin into the hole. At that time, the
umbrella is fully open and ready to use.
TO TILT THE UMBRELLA
Have the umbrella pole fixed firmly with base and rotate the
canopy clockwise or counterclockwise to your desired position.
Continue rotating the canopy to move umbrella into its upright
position.
