2
or decrease rapidly; after the button is released, the screen displays setting temperature.
4. Put the handle on the bracket, then the equipment will be automatically switch to the dormancy
condition; when the temperature is reduced to 100
℃
, “SLP” will be displayed.
5. Temperature below 100
℃,
will display
“SLP“ if not use and enter standby mode.
6. Press "
▲", “▼" at the same time to start the machine and restore the factory settings.
7. Press "set" key to start the machine, and select the temperature unit
℃ / ℉
.
Calibrating temperature
1. Press "set" and "
▲" keys at the same time to calibrate the temperature of the air gun, and then
input the measured actual temperature value.
2.
Press "set" and
“▼” keys at the same time to calibrate the temperature of the soldering iron, and
input the actual temperature value for measurement at this time.
3.
Press "set" to select the adjustment position and exit, press "
▲"
,
“
▼” to adjust the number.
Note:
Temperature for hot air measurement is located in the middle point of about 3mm inside the air
nozzle.
Explanation of symbols
A.
“SLP”
represents the temperature is lower than 100
℃
in standby mode, while the handle is put on
the bracket.
B.
“S-E”
represents the switch turned on but the connector of heat gun(Soldering iron) did not
connect to the station properly or the sensor of heat gun(Soldering iron) damaged; please replace
a new heat gun(Soldering iron).
Terms of use
1. The air outlet and its surrounding area may be very hot. Be cautious of scald.
2. The heat gun shall not be put on the working table or other place except its holder.
3. Please keep the air outlet unblocked.
4. Place the heat gun on its holder after the work, and keep it cool naturally and turn into standby
mode, then switch the power off.
5. The distance between the air outlet and the object shall be no less than 2mm.
6. Choose suitable nozzle in accordance with working requirements. Different nozzles may have
different temperatures.
7. When the soldering iron is not in use, please put it on the iron holder.
8. If the temperature is too high, the service life of soldering iron head will be reduced, so the suitable
working temperature should be selected.
9. Clean the iron head with cleaning sponge regularly.
10. When the soldering iron is used continuously for a long time, remove the iron tip once a week to
remove the oxide
。
11. After use, the iron tip should be wiped clean and coated with a new tin layer to prevent oxidation
of the iron tip.
12. The temperature of different types of soldering iron tip may be different. The best way to adjust
the temperature is to use a special thermometer for measuring the tip. (refer to "temperature
calibration")
Fuse replacement
When fuse is blown, replace with the same type of fuse. (see below picture)
1. Unplug the power cord from the power receptacle.
2.
The fuse holder is located under the AC power receptacle, use the slotted (
–) screwdriver to
loosen
the fuse holder
3. Replace the fuse with new one
4. Put the fuse holder back in place
WARNING
