Pro's Kit SS-979, Руководство пользователя

Страница: 6 / 31

lower than 100
℃
, the station switching to standby mode.
9. Cut the power off and unplug the power cord if there is no operation for a long
time.
Attention
Please set up the temperature as lower as possible in high airflow volume as to
prolong heating element service life and better IC chips protection.
Setting Up Temperature
1. In the power on state, press the "set" key to select the conversion between air
temperature and soldering iron temperature.
2. Press
“▲”or “▼”key to set up the temperature, the screen displays the setting
temperature.
3.
Press “▲” once the temperature degree increase 1
℃
, and the screen displays
4. the setting temperature.
Press “▼” once the temperature degree decrease 1
℃
,
and the screen displays the setting temperature. When press
the “▲”or “▼”
key continuously, the temperature will increase or decrease rapidly, after the
key is released, the screen displays setting temperature.
5. Put the handle back on the holder after work, the SMD station switched from
heating mode to cooling - off mode automatically. When the temperature is
lower than 100
℃
, the station switch to standby mode.
6. Press "
▲", “▼" at the same time to start the machine and restore the factory
settings.
7. Press "set" key to start the machine, and select the temperature unit
℃
/
℉
.
Calibrating Temperature
1. Press the "set" and "
▲" keys at the same time to calibrate the temperature of
the air gun, and then input the measured actual temperature value.
2. Press the "set" and
“▼” keys at the same time to calibrate the temperature of
the soldering iron, and input the actual temperature value for measurement at
this time.
3. Press "set" to select the adjustment position and exit, press "
▲"
“
▼” to adjust
the number.
Note
Temperature for hot air measurement is located in the middle point of about 3mm
inside the air nozzle.
Note:
Explanation of symbols
A.
“SLP”
represents the temperature is lower than 100
℃
in standby mode, while
the handle put on the bracket.
B.
“S-E”
represents the switch turned on but the connector of heat gun (soldering
iron) did not connect to the station properly or the sensor of heat gun
(soldering iron) damaged, please replace a new heat gun (soldering iron).
Terms of Use