PT-1805 User’s Manual
www.prokits.com.tw
8
To switch off the tool, release the On/Off switch. Activate the lock-off button by
pressing on it.
Note
: For safety reasons, the
“on” switch couldn’t be locked; it must remain
pressed during operation. When you released the switch, it always on
“off”
switch for energy saving.
Controlling the Stroke Rate
Increasing or reducing the pressure force on the On/Off switch enables stepless
stroke-rate control of the tool, light pressure force on the On/Off switch results
in a low stroke rate. The heavy pressure force will increases the stroke rate.
The required stroke rate is dependent on the material and the working
conditions and can be determined by a practical trial.
Reducing the stroke rate is recommended when the saw blade engages in the
material as well as when sawing plastic and aluminum.
After longer periods of work at low stroke rate, the tool might heat up
considerably. Remove the saw blade from the tool and allow the tool to cool
down by running it for approx. 3 minutes.
Adjusting the Cutting Angle
The base plate can be swiveled by 45° to the left or right for mitre cuts.
Loosen screw with hex key and slide the base plate in toward the battery to the
stop. For adjustment of precise mitre angles, the base plate has adjustment
notches on the left and right at 0° and 45°. Swivel the base plate to the desired
position according to the scale. Afterwards, push the base plate to the stop in
the direction of the saw blade.
Pendulum Action Settings
This jig saw is design with six pendulum actions, the settings allow for optimal
adaptation of cutting speed, cutting capacity and cutting pattern to the material
being sawed.
NOTE: Metal or hardwoods should never be cut in pendulum action.
To adjust the cutting action, move the cutting action lever from the six cutting
positions: 0 to 6.
Contact Protector
The contact protector attached to the casing prevents accident touching of the
saw blade during the working procedure, don
’t remove.
Operation for working
Please use a qualified jig saw accessory products, choose the "T" handle saw
blade, and confirm the specifications of the product assembly size.
1. Plunge Cutting
Plunge cuts may only be applied to soft materials, such as wood, gypsum
plaster boards, etc.
Use only short saw blades for plunge cutting. Plunge cutting is possible only
with the mitre angle set at 0°.
