14
15
• Do not short the metal (+)(-) terminals. Wishing to put batteries or electri-
cal devices do not end when (+)(-) device error.
• Do not dismantle or modify the battery.
• Please do not take a hammer or other items to hammer blow, or throw
batteries and trampling, falls, and fall causing a strong impact, heavy blow,
etc.
• Do not use sharp utensils or metal objects to scratch or puncture the bat-
tery.
• Do not place the battery into a microwave, oven, or dryer. Do not place the
battery into high-pressure or high temperature environments.
• Do not mix this product with other brands or other types of batteries
• Before charging or discharging the battery, read the manual.
• Stay away from conductive objects during battery charging and dischar-
ging.
• Keep batteries away from children.
• When the device(s) system is not in use, store in a low humidity, low tem-
perature environment.
• In the event the battery fluid comes into contact with your eyes, do not
rub your eyes. Rinse with water and immediately seek treatment.
• If you detect abnormal heat, odors, or flames coming from the battery,
discontinue using the battery.
• If the battery fluid leaks and comes into contact with the skin, wash with
clean water.
• Do not throw into a fire.
• When discarding or recycling batteries, make sure not to short-circuit (+)(-)
the terminals.
• Please recycle. Do not dispose of old batteries with your household waste;
dispose of them safely at your recycling centre or business where the bat-
teries were purchased.
Step by Step Operation Guide for Treatment
Connecting the Cable to The Device
Connecting the lead wire to the electrodes before applying to the skin.
Preparing the Skin for Running a Session
Proper preparation of the skin covered by the electrodes allows more stimu-
lation to reach targeted tissues, prolongs electrode life, and reduces the risk
of skin irritation. After connecting the lead wire(s) to the stimulator, use the
following steps to prepare your skin at the electrode placement sites:
1. Determine the placement sites for the electrodes.
2. Wash the area with mild soap and water (do not use alcohol). Rinse and dry
thoroughly.
3. Trim excess body hair from the area with scissors (do not shave).
4. Optionally, apply skin prep to the area to form a protective barrier on your
skin. Apply, let dry, and apply electrode as directed. This will both reduce
the chance of skin irritation and extend the life of your electrodes.
5. When removing electrodes, always remove by pulling in the direction of
hair growth.
6. It may be helpful to apply skin lotion on electrode placement area when
not wearing electrodes.
