Page 2 of 11
Fig. 1
Noting the orientation of the Awning Brackets as pictured, check that Awning will
not interfere with opening doors once fitted. If there is not enough clearance use the
alternative orientation of the Awning Brackets. If there is enough clearance, secure the
2 x Awning Brackets to the M8 Spring Nuts in the Crossbars by referring to Figure 1.
Tighten to 4Nm with 6mm Allen Key provided or a suitable Torque Wrench.
1
Insert 2 x M8 Spring Nuts at an equal distance from the ends of a pair of crossbars on
the same side of the vehicle. Push Spring Nuts down into the crossbar channels and
twist to lock into place as pictured.
Use the Awning Brackets to ensure Spring Nuts align with holes on the Awning
Brackets.
4
Slide 2 x M6 Hex Bolts into the top channel and 2 x M6 Hex Bolts into the bottom
channel of the mounting extrusion on the rear of the awning.
Once all four bolts have been placed into the extrusion, use the measurement from
the previous step to position the bolts so that they align with the holes on the Awning
Brackets.
Awning Bracket
2
3
Measure the distance of the centre of the holes in the Awning Brackets between each
crossbar.
INSTALLING SHADE AWNING DIRECT TO PRORACK HD, TRADESMAN AND OTHER
HEAVY DUTY CROSSBARS
M8 Spring Nut
M8 Washer
M8 Spring Washer
M8 Socket Head
Capscrew 25mm
Alternative Awning Bracket Orientation
Note - Additional
washers not supplied