9
10
3TUNT2OLL"UTTON
T
S
R
NOTE: To exit the stunt roll mode without flip, you can press the button again. The beeping
sound will stop.
HOW TO PERFORM 360º STUNT ROLLS
Performing 360º stunt rolls with the X18 is as easy as 1-2-3:
1. Hover the X18 in still position making sure that you have at least 5 feet of clearance above and below
the quadrocopter, then set the speed settings to mode 2 or 3.
2. Press the 360 stunt button down and you will enter the stunt roll mode which is indicated by rapid
beeping (see diagram S) sounds.
3. Determine which direction you want it to flip and quickly push the right control stick in the direction
you want to flip your X18 (see diagram T).
You have 4 choices a) Forward roll, b) Backwards roll, c) Right side roll, d) Left side roll.
CALIBRATING THE X18
NOTE: Your X18 comes pre-calibrated out of the box so you are ready to fly.
After several crashes and shocks to your gyro sensors, you may notice that your drone is drifting and can
not hold its center position as well as it used to.
This most likely means that you need to recalibrate your X18. Please follow the simple instructions
below.
1. Place the X18 on a flat level surface
2. Make sure the X18 is on and that the controller is synced (refer to syncing pg 4). Do not start the blades!
Move both the throttle and control stick down to the right corners (see diagram R). You will hear a long
beep and see the lights on the drone rapidly flash for a few seconds then stop. Once the lights stop
flashing you have completed your calibration and are ready to fly!
TROUBLE SHOOTING
: If you do not see the lights flash, first remove the battery from the drone then turn off
your controller and start again. Always make sure to put your battery in first, then turn on your controller.
Push the left throttle stick up all the way and then pull back down again. When you hear the beep the X18 is
synced to the controller and you are ready to calibrate.
