2. MAIN INPUT
This is female XLR-type connector that accept a balanced
line-level signal from a mixing console or other signal source.
7. LOW CUT SWITCH
Use this switch, you can balance this system as a Mid-High by Low Cut Switch on. As a full range system, the switch
should be off.
6. PEAK INDICATOR
The PEAK indicator built to prevent the amplifier outputs from over driving the transducers. It lights when the limiter
is activated. And it s okay for the PEAK indicator to blink occasionally, but if it blinks frequently or lights continuously,
turn down the level control until the PEAK indicator only blinks occasionally.
3. THRU (FULL RANGE OUTPUT)
This is male XLR-type connector that produces exactly the
same signal that is connected to the MAIN INPUT jack. Use
it to daisy-chain several active system together of the same
signal source.
4. MIC. GAIN
This adjusts the MIC. Level.
8. POWER SWITCH
Use this switch to turn the system on and off. Make sure the signal source s level control is turned down before you
turn it on.
9. POWER OUT
This is AC power out to top system or another active system which equipped with powercon-3.
10. POWER IN
This is where you connect the AC linecord to provide AC power. Plug the linecord into an AC socket properly con-
figured for your particular model.
11. FUSE HOLDER
When occur a problem on this appliance, the fuse will be cut off power to prevent from a problem. To replace, use
standard fuse as specified on this appliance.
1. MIC. / LINE INPUT
This is XLR-type for Mic. Inputs, as well as 1 /4 TRS (tip-ring
sleeve) input jack.
5. EQ CONTROL
To adjust the EQ control for setting the balance of system.
TOURING ACTIVE SYSTEM
1. When first powering-up the product, keep the amplifier gain controls all the way off, in order to prevent from being
potentially damaged and from producing annoyed sounds caused by defective cables or hookups. When turning
up gain control, do it gradually, until normal operation is verified. These precautions are necessary for all speaker
system with high power amplifiers, since they have enough power to blow most speakers in abnormal situations.
2. Check the AC Voltage before connectiong the AC plug.
PRECAUTIONS
1
2
THRU
3
4
5
6
7
8
9
10
11
REAR PANEL DESCRIPTION-----
TOP SYSTEM
