P.7
DISTORTION
-
Ensure the volume level of headphone is set to an approximate level.
-
The headphone is too far from the transmitter, move it closer.
-
The audio signal input level is too low. Increase the volume of the audio
source.
TECHNICAL SPECIFICATIONS
Transmission Mode
:
UHF stereo
Carrier Frequency
:
2.4GHz Digital
Operation Voltage
:
Transmitter, DC 9V 400mA
Headphone, 3 x AAA size Rechargeable NiMh
batteries (included)
Frequency Response
:
30Hz – 22KHz
Distortion
:
0.4%
S/N Ratio
:
80dB
Operation Distance
:
Up to 200 feet
NOTE:
1. Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
Installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
