PRO 10 PB (PBE)
This document is protected by copyrights.
Copying, using, or distributing without permission of PROMOTECH is prohibited.
24
4.5.3. Installing
Remove
the
existing
expanding
mandrel.
To
do
this, loosen the nut and use the 5 mm
hex wrench to loosen the set screw (
1
, Fig. 3) to at least one turn. Then, rotate the
spoke handles to the left to disengage the mandrel from the machine.
Use the same 5 mm hex wrench to unscrew the screws (
3
, Fig. 2) and remove
the existing tool holders.
Then, use eight screws to install the milling unit for oval pipes to the spindle disk
(Fig. 11a). Next, install the tool holder using the 5 mm hex wrench (Fig.
11b), and
insert a tool
bit
into the holder according to the rotation direction. Tighten the tool bit
with the 4 mm hex wrench.
Fig. 11.
Installing the attachment for oval pipes
Then, use the following table to select suitable standard jaw blocks and adapters,
and screw them to the large expanding mandrel (Fig. 2).
M6x20
M6x20
M6x30
M6x30
M6x16
Rotation direction
b)
a)
