Promise ULTRA33, Руководство пользователя

Страница: 5 / 12

5
ATAPI CD-ROM Installation
ATAPI IDE CD-ROM drives are
recommended to be installed on a
separate IDE controller such as PCI
IDE controllers integrated on the
Mainboard.
Attach the ATAPI CD-ROM to the
IDE controller. In the Mainboard
Standard CMOS Setup, set the
Drive Type to “Not Installed” or
“None” for the drive. Follow the
CD-ROM manufacturer
6 6
Installed into PCI Slot
Bootable Secondary
ATAPI CDROM
PR
O
M
I
S
E
PR O MIS E
T ec h nol o g y, I nc .
PD C202 43
PR
O
M
IS
E
Te
c
h
n
ol ogy
, I
nc.
© Co
pyr
ight
199
7
Drive 0
Drive 1
instructions.
DOS, Windows 3.1x, and Windows95 Installation
This section gives installation notes on installing your ULTRA33
controller with DOS and Windows 3.1x operating systems.
Working with Existing OS Installations
Previous installations which consist of hard disks >504MB may have
software that accompanies drives to access the full capacity. These
software include Disk Manager and EZ Drive. They must be removed
with their respective uninstall program since repartitioning will not
erase all the driver information that reside in the drive boot sector. If
this fails, from a floppy boot, TYPE “FDISK /MBR” at a prompt.
Installing DOS
For first time installation, follow the standard methods of installing
the DOS operating system onto your hard disk:
Place “Disk 1” of your DOS installation diskettes into the A: drive
and type “A:\SETUP” at the A: prompt. Follow the normal DOS
installation procedures and refer to your DOS manual. OR
Place a DOS bootable diskette into the A: drive. At the A: prompt,
run your DOS FDISK utility program. Create a Primary partition
onto the hard disk - the entire drive capacity should be accessible (if
the entire capacity does not appear, refer to Chapter 6: In Case of
Trouble). The utility program will continue until it asks you to put a
DOS bootable floppy into the system and press a key to restart the
system. After rebooting to a DOS bootable floppy, run the DOS
FORMAT command with the /S - type “FORMAT C: /S” from the
A: prompt. Refer to the DOS Operating System manual for
installation and partitioning/formatting additional hard disks.
5 5
Drive Installation