M
AnAgeMent
P
Ath
-
network
connection
The Gigabit Ethernet RJ-45 ports on the rear panel for the network connection
used for device administrator. These ports must be physically and logically
located in the IP subnet used by the system administrator.
To establish the management path:
1.
Attach one end of an Ethernet cable to the network connector or
standard NIC in the Host PC.
Attach the other end of the Ethernet cable to one of the ports on the standard
network switch on the subnet used for system administration.
2.
Attach one end of an Ethernet cable to one of the ports on the same
network switch or subnet used for system administration.
Attach the other end of the Ethernet cable to one of the 1000BASE-T ports on
the back of the Vess A6120
.
If you have multiple Vess A6120
systems, Host PCs or Servers, repeat steps
1 and 2 as required.
3. Follow the instructions for connecting to, and configuring the basic
settings of the Vess A6120.
Please note that you do not need to establish a network connection
for the initial setup. The web-based management interface is
accessible using a keyboard and monitor directly attached to the
device. See the next section for instructions.
t
Ask
5: c
onnecting
the
p
oweR
Insert one power cable into the power receptacle for the power supply and
connect the PSU to a suitable power source.
P
ower
o
n
V
ess
a6120
systeM
With the power supplies connected, the system can now be powered on.
To power on the Vess A6120 system , press the Power button on the front
panel (see “Front Panel without bezel cover” on page 3
for location of
power button). Observe the LEDs on the front panel (see
page 14
), and
on the back panel (see
page 13
), to make certain the boot up proceeds
smoothly and the system is connected to the network.
Promise Technology
12
Quick Installation Guide
