1.
Remove the black protective rubber cap (2) by pulling off by turning it clockwise. Make sure
that you do not loosen the sensor cap.
A0645
1
2
3
4
5
6
Fig. 6: Installation in the bypass fitting
1. Threaded sleeve
2. Clamp disc
3. Sensor
4. O-ring
5. Washer
6. Bypass fitting
2.
Fit the sensor as described in the operating instructions for the bypass fitting. Only use the
mounting kit, order number 815079, for installation, which is not included in the scope of
delivery.
Unlike the description, guide the parts of the mounting kit from below over the position of the
mounting for the clamp disc (1). Then insert the clamp disc seal (3) into the mounting (1).
Assembly and installation
17
