Safe Digital Lock
PS650/E33
USER MANUAL
www.promet-safe.com
Ver. 1/1 от 31.01.2018г.
Checking the new User Code:
[ON][new PIN2][Enter]
4.4
Deleting the User Code
[ON][Enter][0][Enter][1-9 (user number)]
[Enter][PIN1][Enter]
4.5
Switching off/switching on the sound
[ON][Enter][5][Enter][PIN1][Enter]
5
Time Delay Function
5.1
Switching on the Time Delay function
[ON] [Enter] [6] [Enter] [PIN1] [Enter]
[01-99 – delay time] [1-9 – time for
opening] [Enter]
E.g.: 092
– 9 minutes is the delay time, 2
minutes is the time for opening
5.2
Opening the Lock with the Time Delay
[ON] [PIN1 or PIN2] [Enter](Waiting Delay
Time. Acoustic signal will inform about
the end.)[PIN1 or PIN2] [Enter]
Pressing [Enter] during Time Delay leads to an
interruption. Operation has to be started again.
5.3
Switching off the Time Delay function
[ON] [Enter] [6] [Enter] [PIN1] [Enter]
[000] [Enter]
6
Dual Code Function
6.1
Switching on the Dual Code function
Before switching on the function, make sure you
have assigned a User Code [PIN2] see par.4.2.
[ON] [Enter] [7] [Enter] [1-9 (user
number)] [Enter] [PIN1] [Enter]
6.2
Opening with the Dual Code function
[ON][PIN1][Enter]
[PIN2][Enter] – in 1 minute
If the time delay is set, you have to wait the set
delay time before entering PIN2.
You
have 60 seconds
to enter
PIN2
independently of time of opening you have
entered before (see par.5.1)
6.3
Switching off the Dual Code function
[ON] [Enter] [8] [Enter] [PIN1] [Enter]
7
Servicing
7.1
Changing the Battery
The battery is located on the inner side of the
door.
Battery box and its location depends on the safe
model
Take out the cover of the battery compartment,
change battery with a new one (9V, type 6LF22).
Take the cover or the box back to their location.
7.2
Opening the lock when the Battery is Flat
Take out the plastic cover for emergency power
(5), see Fig. 7.1.
Fig. 7.1
7.2.1
Opening the lock with a Battery
Take a new battery (9V, type 6LF22).
Press the new battery to emergency power pins
and fix it in this position (see Fig. 7.2).
Do not touch
the battery’s contacts to the metal
parts of the lock in order to prevent possible
discharging of the battery.
Fig. 7.2
Enter the valid code on the keypad (1).
Disconnect the emergency battery, open the door
and change the discharged battery, see par. 7.1.
7.2.2
Opening the lock with the emergency key
Remove the screw with a screwdriver (Fig.7.3),
gently move the keypad without damaging the
cable (Fig.7.3).
Fig. 7.3
Insert a screwdriver in the groove of the drive key
and tap it until it stops (Fig.7.4), turn left (Fig.7.4)
and remove the drive key.
Insert the emergency into the keyhole, open the
lock (Fig.7.5).
Fig. 7.4 Fig. 7.5
