Safe Digital Lock
PS610/E36
USER MANUAL
www.promet-safe.com
Ver. 1/3 25.02.2019г.
[ON][new PIN2][Enter]
4.3
Changing the User Code [PIN2] without the
Master Code
[ON] [Enter] [3] [Enter]
[1-9 (user number)] [Enter] [PIN2] [Enter]
[new PIN2] [Enter]
[repeat new PIN2] [Enter]
Checking the new User Code:
[ON][new PIN2][Enter]
4.4
Deleting the User Code
[ON][Enter][0][Enter][1-9 (user number)]
[Enter][PIN1][Enter]
4.5
Switching off/switching on the sound
[ON][Enter][5][Enter][PIN1][Enter]
5
Time Delay Function
5.1
Switching on the Time Delay function
[ON] [Enter] [6] [Enter] [PIN1] [Enter]
[01-99 – delay time] [1-9 – time for
opening] [Enter]
E.g.: 092
– 9 minutes is the delay time, 2 minutes is
the time for opening
5.2
Opening the Lock with the Time Delay
[ON] [PIN1 or PIN2] [Enter] (Waiting Delay
Time. Acoustic signal will inform about
the end.)[PIN1 or PIN2] [Enter]
Pressing [Enter] during Time Delay leads to an
interruption. Operation has to be started again.
5.3
Switching off the Time Delay function
[ON] [Enter] [6] [Enter] [PIN1] [Enter]
[000] [Enter]
6
Dual Code Function
6.1
Switching on the Dual Code function
Before switching on the function, make sure you have
assigned a User Code [PIN2] see par.4.2.
The Dual Code function has priority over other lock
functions.
[ON] [Enter] [7] [Enter] [PIN1] [Enter]
When press [ON] button, switched on Dual Code
function indicates [
G]
2
(see par.2.3).
6.2
Opening with the Dual Code function
[ON][0-9 (user number)][Enter]
[PIN2][Enter]
[0-9 (user number)][Enter]
[PIN3][Enter] – in 1 minute
The User number of Master Code is [0].
After right first Code was entering [PIN2][Enter], for
enter the second Code [PIN3][Enter] there are just 1
minute, that indicates [
G]
1
(see par.2.3) every 5
seconds.
6.3
Switching off the Dual Code function
[ON] [Enter] [8] [Enter] [PIN1] [Enter]
7
Servicing
7.1
Changing the Battery
The pullout battery box (5) is located on the
inner side of the case (1).
Remove the screw blocking the battery box (see
Fig.7.1).
Squeeze latches and pull the battery box down
(see Fig.7.1).
Fig. 7.1
Disconnect the battery from the contact pads,
placed to the right, as shown in Fig.7.2.
Fig. 7.2
Remove the battery and replace it with a new
one (9V, type 6LF22).
Take the box and screw it back in the reverse
order to their location.