mechanical installation
return and repair
electrical mounting
- The electrical installation must be carried out with the power off.
- Insert the connection cable into the cable entry (screw connection). Be careful not to
damage the seal of the cable gland.
- Connect the connecting cables according to your circuit task.
- You can parameterize the device via the USB interface.
- Close the case and switch on the voltage
The promesstec sensor have a modular design. This allows us to repair and overhaul
defective devices. To do this, send the device to promesstec. You will find a return form
with the information to be provided on our homepage under „technical information“.
disposal of the devices
Dispose of devices, components and packaging in an environmentally friendly manner
in accordance with the waste treatment and disposal regulations typical for the country.
Pay attention to waste separation and the recycling of high-quality materials such as
stainless steel, etc.
further documentation
Important information !!!
Mounting instructions !!!
temperature measurement
version 2.1.1 page 4/4
You can find these quick start guide and the data sheets as a file on our homepage under
the respective devices. The documentation is available in German and in English. Other
languages on request.
- Only use promesstec welding sleeves and process connections for the adaptation in your
process. Only by this we can guarantee you an optimal measuring point.
- After installing the sensor, check the tightness of the measuring point.
promesstec GmbH * Niedersachsenstraße 4 * 48465 Schüttorf * Tel.:+49 (0)5923/ 90229-0 * Fax +49 (0)5923/ 90229-29 * E-Mail: [email protected] * Internet: www.promesstec.com
