Setup
:
The GT1 Tomahawk has two Arca Compatible base plates on the bottom which
allows you to mount the Tomahawk from the side base plate (F) or the bottom
base plate using an Arca Style Clamp. The Tomahawk can also be mounted to
any ¼-20 surface/plate using the threaded holes. (E)
1. Mount the GT1 Tomahawk onto a compatible clamp vertically or horizontally
onto your ball head, monopod head, or other gear. You can also choose to
mount it directly to your tripod or monopod by using the
¼
-20 mounting hole.
Mounting the Lens and Operation:
In order to mount a lens onto the Tomahawk your lens must be equipped with
an Arca Compatible Lens Plate.
1. To mount, open the lens Arca Compatible Clamp (C) by loosening Clamp
Knob (B). Then slide the Arca Compatible Lens Plate attached to the lens into
the Clamp and tighten Clamp Knob (B).
2. To balance, while holding the camera and lens with a light touch loosen Tilt Lock
Knob (A) so the arm is free to swing and also slightly loosening Clamp Knob (B). Now
you will be able to slide your camera and lens plate forward or backward in the clamp
unitl the lens is perfectly horizontal and not drooping. Once neutral balance is found
remember to lock the Clamp Knob (D) securely. You may also set your resistance on
Tilt Lock Knob (A)
a. If the Lens is pointing DOWN, loosen the Clamp knob (D) and move camera/lens
backwards. Set resistance on Tilt Lock Knob (A) when complete.
b. If the Lens is pointing UP, slightly loosen the Clamp Knob (D) and move camera/
lens forward. Set resistance on Tilt Lock Knob (A) when complete.
Instructions
D. Safety Stop Screws
A. Tilt Lock Knob
B. Clamp Knob
C. Arca Compatible Clamp
E. 1/4-20 Mounting Threads
F. (Dual) Arca Compatible Base
D. Safety Stop Screws
