- 2 -
2 INSTALLATION
The printer is battery powered, thus the installation procedure is reduced only, to
connect the provided cable to the level meter serial connector. Before this operation, turn
the power off of both equipments.
Consult the level meter instruction manual in order to locate its RS-232C connector.
3 OPERATING INSTRUCTIONS
Refer to the INSTRUCTION MANUAL to carry out printing reports.
3.1 CI-23 set-up
Figure 1.-
CI-23 keyboard
[1]
POWER LED
[2]
SET-UP
[3]
FEED
[4]
ON
[5]
OFF
To initiate the set-up mode push the
[2] SET-UP
and the
[4] ON
keys. The
[1] POWER
ON
LED will flash until set-up mode is turned off. The current parameter status will be
printed. The status of the DATA BITS parameter will be printed in order to modify it if
necessary.
To select the status of the resting parameters (PARITY, BAUD-RATE, COUNTRY,
PRINT MODE, AUTO-OFF, EMULATION and DTR) push the
[3] FEED
key. These
parameters are selected in a sequential way. To modify the status of any parameter push
sequentially the
[2] SET-UP
key. Example:
SERIAL BAUD RATE: 300, 600, 1200, 2400, 4800, 9600, 19200, 300...
When all the necessary changes have been made, push the
[2] SET-UP
and
[3] FEED
keys to update the configuration of the printer. If no key is pressed for 15 seconds the set-
up mode will be terminated without changing the original parameters.
12/99
CI-23
