other Bluetooth audio player. Before pairing, please make sure your Bluetooth stereo
receiver supports Bluetooth A2DP profile. The pairing steps are as follows:
Under TX Mode
1) Make sure the transmitter is off, otherwise switch it off;
2) Keep the transmitter and your Bluetooth stereo receiver within 1 meter;
3) Switch on your Bluetooth stereo receiver and make it enter pairing mode;
4) Press and hold MFB button of the transmitter for 5
～
7 seconds and do not release it
until red and blue LEDs flash alternately, at this time, the transmitter entered pairing
mode;
5) The transmitter will automatically search for Bluetooth stereo receiver and finish
connection;
6) After successful connecting, blue LED of the transmitter flashes twice every 4
seconds;
7) Connect the transmitter to your music player or MP3 player through 3.5mm audio
jack to transmit music to a Bluetooth headphone to the play music.
8) Connect the receiver to your speakers through 3.5mm audio jack to transmit the
sound coming from any Bluetooth audio player.
Under RX Mode
1) Keep the receiver and Bluetooth cell phone within 1 meter when pairing;
2) Enter the receiver’s pairing mode (refer to “How to enter pairing mode”);
3) Active your cell phone’s Bluetooth function and set your cell phone to search for
Bluetooth devices within range. After the search is completed, select “ProHarmony.3D”
from the list of devices shown;
4) According to the indication, enter password or PIN No:“0000”;
5) If prompted by your cell phone to connect, select “Yes”;
6) After successful connecting, blue LED of the receiver will flash twice every 4 seconds.
7) When ProHarmony.3D is used as a receiver, you can connect it to a 3.5mm stereo
headset or stereo speaker with a 3.5mm to 3.5mm audio cable.
Remarks:
・
The pairing mode will last 2 minutes. The transmitter will enter standby mode if no
devices can be connected within 2 minutes.
・
The transmitter can pair with a Bluetooth stereo receiver whose PIN NO.. is “0000”,
“1234”or “1111”, “8888”.
・
Turn the TX/RX switch to RX mode before switching on Bluetooth 3.5mm audio
adapter. TX or RX mode cannot be changed after switching it on.
2.3.3 Reconnecting with a Bluetooth device for the headset
