background image

 

 

 

IMPORTANT: 

 

1.  Make sure to set the switch to the “

OFF

" position when not using the cordless function. 

2.  The test button 

6

 indicates the remaining power of the internal battery (see the graph below). 

 

3.  The battery, AC adapter and charger will get warm during charging. This is normal. 

4. 

Always insert the battery into the charger with the correct polarity.

 

5. 

Always keep metal contacts on both charger and battery clean by wiping the surfaces with a dry, soft and clean cloth.

 

6. 

All batteries will naturally discharge themselves even if they are not in use. To prolong their service life, it is 
recommended that you do not let a battery sit idle for more than two months without recharging. Recharge your batteries   
before you plan to use them.

 

7.  Remove your batteries from the device (digital camera, music player or other portable electronic device after use. These 

devices will continue to drain a small current from your battery even if they are turned off. 

 

TROUBLE SHOOTING: 

 

 
If the RED (charge) LED indicator does NOT light up when the charger is plugged into a power source and the 
batteries have been inserted: 
•  

The battery may not be properly inserted. Unplug the charger from power source and check to make certain the batteries 

are seated properly. 

•  

Check and make sure metal contacts on both charger and battery are clean. 

 

If the battery takes a much shorter time to reach full charge:  
• 

There may still be some power left in the battery prior to being charged.  

• 

The battery is getting old and should be replaced.    

 

If the battery is providing a much shorter operating time after being fully charged,  
•  

The battery may have sat idle without being charged for too long.

 

• 

The battery is worn out and about to reach the end of its service life. All rechargeable batteries will eventually wear out 
after being used for a certain number of cycles. 

 

LIMITED WARRANTY: 

 
This product carries a full one-year warranty from the date of purchase, against defects in materials and workmanship. This 
warranty does not cover damage resulting from accidents, misuse, unauthorized repair/alterations to the product or failure to 
follow operating instructions. If the product should become defective within the warranty period and under above mentioned 
conditions, please return it to the store you originally purchased it from with proof of purchase, for repair or replacement free 
of charge.  
 
 
 
Made in Taiwan 
 
 

 

 
 

Содержание XtraPower GO!

Страница 1: ...rough the USB port of a PC laptop only Do not store place or use the GO Charger where it could come into contact with water or moisture Do not recharge the GO Charger under direct sunlight or in an unattended vehicle Do not short circuit the metal contacts on the charger Do not disassemble deform or reconstruct any part of the GO Charger OPERATING INSTRUCTIONS A GO Charger USB Power Supply B 12 24...

Страница 2: ...t the internal battery is charging 5 When both the battery in the charging port 3 and internal battery are fully charged the LED 5 will turn GREEN 6 When charging your battery through a PC or laptop USB port you can still upload or download through any device connected to the USB socket 4 7 Please remove the battery after it is fully charged While it is safe to leave the battery in the charger do ...

Страница 3: ...have been inserted The battery may not be properly inserted Unplug the charger from power source and check to make certain the batteries are seated properly Check and make sure metal contacts on both charger and battery are clean If the battery takes a much shorter time to reach full charge There may still be some power left in the battery prior to being charged The battery is getting old and shou...

Страница 4: ...PROMASTER PNFC 10 PROMASTER PNP 20 PKLIC 7002 PNP 60 PNP 120 PNFC 10 PROMASTER PKLIC 7002 PROMASTER PNP 20 PNP 60 PNP 120 The charger may fail to work properly if these instructions are not followed ...

Отзывы: