Remote Control Function Identification
A. Flash mode selection
B. Modeling lamp mode selection
C. Buzzer mode selection
D. Optical slave mode selection
E. Flash output power display
F.
Modeling light output display
G. Signal Indicator
H. Vertical select / function adjustment dial
I.
Power/Remote light power switch
J.
Channel selection key
K. Test flash button
L.
Horizontal menu select button (OK)
M. Battery cover
N. X synchronization line jack
O. Hot shoe contact
P.
Shoe locking ring
Using the remote control
1. Open the battery cover (M) and install two AAA batteries. Be sure to insert them with the positive and negative
facing the direction of the diagram in the remote housing.
2. Power on the remote using the power button (I). Be sure that the remote is set to the same channel as the light
you wish to control. Note, if the remote is set to a different channel, after you have set the light to the matching
channel, pressing any remote key will wake the light you are controlling.
3. Insert the shoe of the remote control into the hot shoe on your camera. If the camera does not have a hot shoe,
you will need to connect the remote to the camera using the X-sync cord. Plug the cord into the X-sync jack (N)
of the remote and the other end into the camera's X-sync port. Press the shutter button to test the flash. Note:
The flash must be set to the CELL + FM, CELL +1, or CELL +2 setting.
4. To make flash settings, press the Mode Dial (H) until the setting you wish to change flashes. Use the OK button
to toggle through the options until the option you wish to choose flashes. Press the Mode Dial (H) to select and
store the setting. Note that you will have approximately 5 seconds to activate your choice. After that time, the
selection will return to the previous state.
5. After approximately 2 minutes of inactivity, the remote will go to sleep to conserve power. Pressing the power
button (I) will reactivate the remote.
Using the Monolight
1. Plug the power cord into the AC input socket (F) of the light. Turn on the main power switch (J). The power
indicator (Y) will blink indicating the light is in the standby mode. Pressing the remote power button (H) on the
light or the power button on the remote (I) will activate the lights operational mode.
