Promaker PRO-TP550KIT, Руководство пользователя

Страница: 7 / 24

7
the auxiliary handle (5) clockwise.
Insert a drill bit:
a) To open the drill’s chuck, whilst
completely switched off, take firm
hold of the black part of the chuck
and turn the part of the chuck
counter clockwise.
b) Insert the drill bit, screwdriver bit,
or other tool/accessory required for
the task, into the chuck. In order to
obtain a secure fastening of the bit,
insert the bit as far as you can into
the chuck. Take firm hold of the back
part of the chuck and turn the front
part of the chuck clockwise until it is
firmly closed.
c) In order to remove accessories
from the chuck, follow the same
steps as indicated previously but in
reserve order.
Screwing, drilling/unscrewing
a) To drill or screw, ALWAYS have
the direction set to clockwise (CW).
b) The unscrew, set the direction to
counter clockwise (CW).
c) The appliance should not be in use
when changing the screwing direction.
Rotation direction change
a) Do not change the direction of
the rotation whilst the tool motor is
in operation.
b) The appliance has a selector (7),
which allows the direction of rotation
to be changed.
Electronic speed control
a) The speed of the appliance can be
regulated by using the speed regulator
control (6). This function is very useful,
as it makes it possible to adapt the
speed of the appliance to the type of
work that needs to be done.
b) If the appliance work continuously at
low speed, working life of the appliance
will be reduced considerably.
Drilling, Driving and Impact Drilling
Drilling and driving
- Shift the selector (2) until the mark
is visible
Impact drilling
- Shift the selector (2) until the mark
is visible
Use
a) Connect the appliance to the
mains.
b)Turn the appliance on, by using
the on/off button.
Locking button
a) To active this function press button
(10) while holding down the run button.
b) To deactivate this function, press
the run button right down.