Promaker PRO-SB1800, Руководство пользователя

Страница: 11 / 96

11
MOUNTING THE TABLE SAW BASE
ON THE LEG STAND
See Figure 8.
• Take the following from the base of
the table saw: 8 hex screws.
NOTE:
• Place the table saw base on the leg
support. Line up the holes in the
table.
• Put a bolt in each hole. Hand
tighten.
• Repeat for the three remaining
holes. Tighten all hardware firmly
with socket rachet.
TO INSTALL THE HANDLE
See Figure
7
.
Insert the screw into the handle using a
Phillips-head screwdriver.
Then insert the screw attached to the
handle into the hole in the bevel / height
adjustment handwheel.
Place the nylon nut on the back of the
hole and tighten the screw.
Tighten until it stops so that the handle
turns freely when you turn the steering
wheel.
Remember to place the plastic cap on
the front of the handle to avoid
accumulation of dust or sawdust.