Promaker PRO-ES750KIT, Руководство пользователя

Страница: 10 / 32

10
WARNING: Ensure the angle
grinder is switch off and unplugged
from the mains.
Depending on whether your operation
is cutting or grinding, select the correct
protective cover. Failure to use the right
cover for operation could result in injury.
When using a grinding or cutting-off
wheel, the protective guard must be
fitted on the tool so that the closed
side of the cover always points toward
the operator.
Install the guard: release the lock lever
of the guard and insert it on the gear
head, and turn/adjust in any desired
position for maximum performance,
then close the lock lever.
Make sure that the fastening lever is
properly locked after setting the guard.
To remove the protective cover, follow
the installation procedure in reverse.
The protective cover can be turned
to a desired angle, but not more than
45° on left side or right side.
CAUTION:
Please use Protective Cover for
grinding operation.
Please use Protective Cover for
cutting-off operation.
Grinding and Surface Processing
In order to grind surface, you should
use a coarse abrasive disk with a
sunken centre.
You can use the abrasive disks with
diameter of 115mm. The maximum
thickness of disks is 6mm.
Cutting metal
In order to cut rods, tubes and metal
parts you should use a cutting-off
wheels with diameter of 115mm.
The maximum thickness of wheels
In this case is 3mm.
Cutting Stone Material
When cutting stone material you
should use the cutting-off wheels
with diameter of 115mm. The
maximum thickness of wheels in
this case is 3mm.
Please use proper wheels to work.
Failure to use the right cover for
operation could result in injury.
WARNING! Cutting operations with